Enables or disables the interface. This parameter is based on ''ifAdminStatus'' from {{bibref|RFC2863}}. The current operational state of the interface (see {{bibref|TR-181i2|Section 4.2.2}}). {{enum}} When {{param|Enable}} is {{false}} then {{param}} SHOULD normally be {{enum|Down}} (or {{enum|NotPresent}} or {{enum|Error}} if there is a fault condition on the interface). When {{param|Enable}} is changed to {{true}} then {{param}} SHOULD change to {{enum|Up}} if and only if the interface is able to transmit and receive network traffic; it SHOULD change to {{enum|Dormant}} if and only if the interface is operable but is waiting for external actions before it can transmit and receive network traffic (and subsequently change to {{enum|Up}} if still operable when the expected actions have completed); it SHOULD change to {{enum|LowerLayerDown}} if and only if the interface is prevented from entering the {{enum|Up}} state because one or more of the interfaces beneath it is down; it SHOULD remain in the {{enum|Error}} state if there is an error or other fault condition detected on the interface; it SHOULD remain in the {{enum|NotPresent}} state if the interface has missing (typically hardware) components; it SHOULD change to {{enum|Unknown}} if the state of the interface can not be determined for some reason. This parameter is based on ''ifOperStatus'' from {{bibref|RFC2863}}. The textual name of the interface as assigned by the CPE. The accumulated time in {{units}} since the interface entered its current operational state. {{list}} {{reference|an interface object that is stacked immediately below this interface object}} See {{bibref|TR-181i2|Section 4.2.1}}. Note: Since {{object}} is a layer 1 interface, it is expected that {{param}} will not be used. Indicates whether the interface points towards the Internet ({{true}}) or towards End Devices ({{false}}). For example: * For an Internet Gateway Device, {{param}} will be {{true}} for all WAN interfaces and {{false}} for all LAN interfaces. * For a standalone WiFi Access Point that is connected via Ethernet to an Internet Gateway Device, {{param}} will be {{true}} for the Ethernet interface and {{false}} for the WiFi Radio interface. * For an End Device, {{param}} will be {{true}} for all interfaces. The maximum upstream and downstream PHY bit rate supported by this interface (expressed in {{units}}). A value of -1 indicates automatic selection of the maximum bit rate. Set this to {{true}} to reset all this object's statistics counters to zero. Set this to {{true}} to reset all this object's statistics counters to zero. Reset all this object's statistics counters to zero. Throughput statistics for this interface. The CPE MUST reset the interface's Stats parameters (unless otherwise stated in individual object or parameter descriptions) either when the interface becomes operationally down due to a previous administrative down (i.e. the interface's {{param|#.Status}} parameter transitions to a down state after the interface is disabled) or when the interface becomes administratively up (i.e. the interface's {{param|#.Enable}} parameter transitions from {{false}} to {{true}}). Administrative and operational interface status is discussed in {{bibref|TR-181i2|section 4.2.2}}. The total number of bytes transmitted out of the interface, including framing characters. The total number of bytes received on the interface, including framing characters. The total number of packets transmitted out of the interface. The total number of packets received on the interface. The total number of outbound packets that could not be transmitted because of errors. The total number of inbound packets that contained errors preventing them from being delivered to a higher-layer protocol. The total number of outbound packets which were chosen to be discarded even though no errors had been detected to prevent their being transmitted. One possible reason for discarding such a packet could be to free up buffer space. The total number of inbound packets which were chosen to be discarded even though no errors had been detected to prevent their being delivered. One possible reason for discarding such a packet could be to free up buffer space. The total number of packets requested for transmission which were not addressed to a multicast or broadcast address at this layer, including those that were discarded or not sent. The total number of received packets, delivered by this layer to a higher layer, which were not addressed to a multicast or broadcast address at this layer. The total number of packets that higher-level protocols requested for transmission and which were addressed to a multicast address at this layer, including those that were discarded or not sent. The total number of received packets, delivered by this layer to a higher layer, which were addressed to a multicast address at this layer. The total number of packets that higher-level protocols requested for transmission and which were addressed to a broadcast address at this layer, including those that were discarded or not sent. The total number of received packets, delivered by this layer to a higher layer, which were addressed to a broadcast address at this layer. The total number of packets received via the interface which were discarded because of an unknown or unsupported protocol. Note that IPv6 does not define broadcast addresses, so IPv6 packets will never cause this counter to increment. Note that IPv6 does not define broadcast addresses, so IPv6 packets will never cause this counter to increment. {{numentries}} {{object}} table (a stackable interface object as described in {{bibref|TR-181i2|Section 4.2}}). {{numentries}} {{object}} table (a stackable interface object as described in {{bibref|TR-181i2|Section 4.2}}). {{numentries}} {{object}} table (a stackable interface object as described in {{bibref|TR-181i2|Section 4.2}}). {{numentries}} {{object}} table (a stackable interface object as described in {{bibref|TR-181i2|Section 4.2}}). {{numentries}} {{object}} table (a stackable interface object as described in {{bibref|TR-181i2|Section 4.2}}). {{numentries}} {{object}} table (a stackable interface object as described in {{bibref|TR-181i2|Section 4.2}}). {{numentries}} {{object}} table (a stackable interface object as described in {{bibref|TR-181i2|Section 4.2}}). {{object}}. {{object}}. {{object}}. {{object}}.